Bild

Zusatzmenue:
Hauptmenue:
Tools:
Untermenue:
Seiteninhalt:

JENOPTIK-VOTAN™ C BIM

bild

Application

The JENOPTIK-VOTAN™  C BIM (Beam In Motion) is the innovative combination of a fixed laser and a robot-supported motion sequence. The laser cutting system is designed and constructed to remove waste edges from door panelling or shoulders, remove excess film from back-injection-moulded parts or to create cut-outs in medium-sized plastic parts, cleanly and leaving no visible or structural damage.

Examples of use



bild
Edge cutting and cut-out at interiour parts of cars
bild
Edge cutting of parts for automotive interior panellings
bild
Door panellings of cars
bild
Edge trimming cut of rubber sealing lip, at car windows

Specific strengths

  • Combines the advantages of a stationary laser with those of a moving robot arm by fully integrating the laser beam guide into the robot arm
  • Considerable reduction of cycle times
  • Significant increase in precision and flexibility
  • Low space requirement (footprint of only 10 m²).
  • Integrated container solution lends the system mobility and reduces transportation costs to a minimum
  • Considerably reduced time and expense required for installation - the user only needs to connect
    the relevant supply lines

HP Pelzer Brings Insulating Material into Form by Laser, "Kunststoff Magazin 12/08"

A new generation of laser cutting systems

JENOPTIK-VOTAN™ C BIM with 1 kW - 2.5 kW laser power

Insulation mats